Table of Contents
Advertisement
Section5. Rudder Elevator Servo &
Linkage Installation
We recommend you to install the rudder servo on
the left tray, elevator servo on the right tray.
Step1. Slide the Φ1.8x600mm (23.6inch) elevator
servo pushrod to the guiding tube. The threaded
end comes first.
Remove the coverings for the exit hole.
www.valuehobby.com/aviator-trainer-25-arf.html
Step2. Thread a clevis to the pushrod, and connect
a control horn to the clevis.
Step3. With the holes aligned with the hinge line,
install the control horn to the elevator using two
M2*10mm (0.4inch) screws and backplate.
Step4. In the same ways install the control horn to
the rudder.
Note: please don't let the rudder pushrod affect
the movement of the elevator when installing the
rudder control horn.
12
Advertisement
Table of Contents
