Table of Contents
Advertisement
Section1. Aileron Installation
Step1. Place T-pin or something similar to this in
the center of each hinge.
Step2. Insert the hinges into the slots pre-cut in the
aileron.
Step3. Use the hinges to place the aileron in
position. Use a hobby knife to set a gap between
the aileron and the wing. Also check the aileron
can move freely without rubbing at the wing foot.
Step4. Saturate each hinges with thin CA. make
sure to glue both the top and bottom. Once CA has
cured, gently pull on the aileron to make sure the
hinges are secure. If not, apply more CA to loose
hinges.
Step5. Flex the aileron up and down several times
to break in the hinges.
Step6. Repeat steps 1 through 6 to install the
remaining aileron.
Advertisement
Table of Contents
