Inner System Board Shield Removal - Lexmark C78x Service Manual

5061

Inner system board shield removal

See "System board inner shield assembly" on page 7-33
1.
Remove the top cover assembly. See
2.
Remove the rear cover. See
3.
Remove the transfer HVPS board. See
4.
Remove the system board. See
5.
Remove the ground wire screw (A). (Shown from above the inner system board shield.)
6.
Remove the five screws (B).
7.
Lay the inner system board shield out of the way.
Installation note: Be sure to replace all the cable ties.
4-48
Service Manual
"Top cover assembly removal" on page
"Rear cover removal" on page
"Transfer HVPS board removal" on page
"System board removal" on page
for part number.
4-13.
4-22.
4-90.
4-92.