Hotspot Services (Ibr600) - Cradlepoint IBR600 Product Manual

IBR600 | USER MANUAL Firmware ver. 4.0.2
CRADLEPOINT

8.4 Hotspot Services (IBR600)

Any of your networks can be enabled as a hotspot. To
enable a hotspot, you need to select a network and set it
as a hotspot in Network Settings → WiFi / Local
Networks.
NOTE: Although any network can be a hotspot, the IBR600 allows
only one hotspot.
Hotspot Mode: Choose from the following dropdown
options:
 Simple: Allows "Terms of Use" page and timeout
settings controlled within the router.
 RADIUS/UAM: Allows you to set up external
authentication servers.
Local IP Network: A single LAN Group—including both
WiFi and Ethernet—can be configured as your hotspot. If you do not already have a LAN Group configured as a hotspot,
go to the WiFi / Local Networks
"Hotspot" for the LAN Group you want to use.
NOTE: Routing Mode is in the Local Network Editor under the IP Settings tab. Select a network in Network Settings → WiFi / Local Networks
and click Edit to open the Local Network Editor. The IP Settings tab will already be open: the Routing Mode dropdown menu is at the bottom.
Allow Service on 3G/4G Modems: Allows you to enable or disable hotspot access to the Internet over a modem. This is
often used if the router has a main wired link and a secondary modem for failover (typically with a more expensive/limited
data plan). Select this option if you want the router to allow data traffic over the modem if the wired connection goes down.
Disable Service if Ethernet Threshold is met: This will block Hotspot use of the WAN when the threshold is met. This
can be used if the router is being used as a backup failover connection to another router with a wired connection. If that
other router's wired connection goes down and it starts using this router for its primary connection, then disable Hotspot
use of the WAN connection. Set the limiting Rate (KB/s) and Time Period (seconds).
Redirect HTTPS Requests: This allows initial requests to HTTPS websites to be redirected appropriately.
Hotspot/UAM Authentication Port: Default: 8000. Type in a different port number, or use the slider to change the port.
© 2012 CRADLEPOINT, INC.
page (you can click Configure to link to this page) and set the Routing Mode to
PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 158