Cradlepoint IBR600 Product Manual page 125

IBR600 | USER MANUAL Firmware ver. 4.0.2
CRADLEPOINT
Page 1: General
7.4.1
Tunnel Name: Choose a name meaningful to you.
Anonymous Mode: Allow remote connections from any IP
address.
Local Identity: This can be left blank for most users. If left
blank it will default to the IP address of the WAN connection.
Currently we only support identifiers in the form of an IP
address, a user fully qualified domain name
(user@mydomain.com) or just a fully qualified domain
name (www.mydomain.com). If the remote side of the tunnel
is configured to expect an identifier, then both must match in
order for the negotiation to succeed.
Remote Identity: This can be left blank for most users. If left
blank it will default to the IP address of the WAN connection.
Currently we only support identifiers in the form of an IP
address, a user fully qualified domain name
(user@mydomain.com) or just a fully qualified domain
name (www.mydomain.com). If no identifier is defined then
no verification of the remote peer's identification will be done.
Authentication Mode: Select from Pre-Shared Key and
Certificate. Pre-Shared Key is used when there is a single
key common to both ends of the VPN. Certificate requires the creation of a set of certificates and a private key that can
be uploaded to the router. Enable Certificate Support in the Global VPN Settings to upload a single set of certificates for
the router to use.
Pre-shared Key: Create a password or key. The routers on both sides of the tunnel must use this same key.
© 2012 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 123