Cradlepoint IBR600 Product Manual page 113

IBR600 | USER MANUAL Firmware ver. 4.0.2
CRADLEPOINT
7.1.6 Update/Activate a Modem
Some modems can be updated and activated while plugged into the router. Updates and activation methods vary by
modem model and service provider. Possible methods are: PRL Update, Activation, and FUMO. All supported methods
will be displayed when you select your modem and click "Control" to open the "Update/Activate" window. If no methods
are displayed for your device then you will need to update and
activate your device externally.
To update or activate a modem, select the device and click
"Control".
The modem does not support Update/Activate methods: A
message will state that there is no support for PRL Update,
Activation, or FUMO.
The modem supports Update/Activate methods: A message
will display showing options for each supported method:
 Modem Activation / Update: Activate, Reactivate, or
Upgrade Configuration.
 Preferred Roaming List (PRL) Update
 Firmware Update Management Object (FUMO)
Click the appropriate icon to start the process.
If the modem is connected when you start an operation the
router will automatically disconnect it. The router may start
another modem as a failover measure. When the operation is
done the modem will go back to an idle state, at which point the
router may restart it depending on failover and failback settings.
NOTE: Only one operation is supported at a time. If you try to start the same
operation on the same modem twice the UI will not report failure and the
request will finish normally when the original request is done. However if you
try to start a different operation or use a different modem, this second request
will fail without interfering with the pending operation.
© 2012 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 111