Table of Contents
Advertisement
IB620C/IB680C/IB820C/IB1020C
A. Remove the splash shield
•
Remove quarter turn connector from the right side
of splash shield.
•
Gently bow the center of the splash shield and lift
up and forward to remove.
Splash Shield must be reinstalled to prevent water
leakage.
B. Remove the water curtain
•
Gently flex the curtain in the center and remove it
from the right side.
•
Slide the left pin out.
C. Remove the ice thickness probe
•
Compress the hinge pin on the top of the ice
thickness probe.
•
Pivot the ice thickness probe to disengage one pin
then the other. The ice thickness probe can be
cleaned at this point without complete removal. If
complete removal is desired, disconnect the ice
thickness control wiring from the control board.
D. Remove the water level probe
•
Loosen the screw that holds the water level probe
in place. The probe can easily be cleaned at this
point without complete removal. If complete
removal is desired, remove the top cover, left and
right side panels and control box cover. Disconnect
the wire lead from the control board inside the
electrical control box.
Part Number 80-1505-3 6/11
Important
91
- Quick Links:
- General Information
- Model Numbers
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the QuietQube SD0672C and is the answer not in the manual?
Questions and answers
does this machine need filters on water line before entering the machine
The Manitowoc SD0672C machine does not explicitly require filters on the water line, but it is recommended to treat the water to inhibit scale, filter sediment, and remove chlorine odor and taste. If a Manitowoc water filter system is used, the installation instructions for the filter should be followed.
This answer is automatically generated