Front Panel Connector (Frontpnl) (J19) - Kontron KTQM67/mITX User Manual

KTD-N0819-K
6.11

Front Panel Connector (FRONTPNL) (J19)

Pull Ioh/
Note
U/D Iol
- -
- -
- -
- -
- -
- -
- 25/25mA
- -
4K7 -
- -
- -
- -
Signal Description
5V supply for external devices. SB5V is supplied during powerdown to allow wakeup
USB10/11_5V
on USB device activity. Protected by resettable 1.1A fuse covering both USB ports.
USB1+/USB1- Universal Serial Bus Port 1 Differentials: Bus Data/Address/Command Bus.
USB3+/USB3- Universal Serial Bus Port 3 Differentials: Bus Data/Address/Command Bus.
Maximum load is 1A or 2A per pin if using IDC connector flat cable or crimp terminals
+5V
respectively.
SATA_LED# SATA Activity LED (active low signal). 3V3 output when passive.
SUS_LED Suspend Mode LED (active high signal). Output 3.3V via 470Ω.
Power Button In. Toggle this signal low to start the ATX / BTX PSU and boot the
PWRBTN_IN#
board.
Reset Input. When pulled low for a minimum 16ms, the reset process will be initiated.
RSTIN#
The reset process continues even though the Reset Input is kept low.
LINE2 Line2 is second stereo Line signals
MIC2 MIC2 is second stereo microphone input.
SB3V3 Standby 3.3V voltage
AGND Analogue Ground for Audio
Note: In order to meet the requirements of USB standard, the 5V input supply must be at least 5.00V.
Available cable kit:
Page 57
Type Signal PIN
PWR USB6/7_5V 1
USB6- 3
USB6+ 5
PWR GND 7
NC NC 9 10
PWR +5V 11 12
O SATA_LED# 13 14
PWR GND 15 16
I RSTIN# 17 18
PWR SB3V3 19 20
PWR AGND 21 22
AI MIC2-L 23 24
PN 821042 Cable Front Panel Open-End, 300 mm
Internal Connectors
Signal Type
2 USB6/7_5V PWR
4 USB7-
6 USB7+
8 GND PWR
LINE2-L
+5V PWR
SUS_LED O
PWRBTN_IN# I
GND PWR
LINE2-R
AGND PWR
MIC2-R AI
KTQM67 Users Guide
Ioh/ Pull
Note
Iol U/D
- -
- -
- -
- -
- -
- -
7mA -
1K1
- -
- -
- -
- -