Kontron KTQM67/mITX User Manual page 114

Hide thumbs Also See for KTQM67/mITX:
Table of Contents

Advertisement

KTD-N0819-K
Function
Terminal Type
Bits per second
Data Bits
Parity
Stop Bits
Flow Control
VT-UTF8 Combo Key
Support
Recorder Mode
Resolution 100x31
Legacy OS Redirection
Resolution
Putty Keypad
Redirection After BIOS
POST
Page 114
Selection
VT100
VT100+
VT-UTF8
ANSI
9600
19200
38400
57600
115200
7, 8
None
Even
Odd
Mark
Space
1
2
None
Hardware RTS/CTS
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
80x24
80x25
VT100
LINUX
XTERMR6
SCO
ESCN
VT400
Always Enable
BootLoader
BIOS - Advanced
Description
Emulation: ANSI: Extended ASCII char set.
VT100: ASCII char set. VT100+: Extends
VT100 to support color, function keys, etc. VT-
UTF8: Uses UTF8 encoding to map Unicode
chars onto 1 or more bytes.
Select serial port transmission speed. The
speed must be matched on the other side. Long
or noisy lines may require lower speeds.
Data Bits
A parity bit can be sent with the data bits to
detect some transmission errors.
Even: parity bit is 0 if the num of 1's in the data
bits is even.
Odd: parity bit is 0 if the num of 1's in the data
bits is odd.
Mark: parity bit is always 1.
Space: parity bit is always 0.
Mark/Space do not allow error detection.
Stop bits indicate the end of a serial data
packet. (A start bit indicates the beginning).
The standard setting is 1 stop bit.
Communication with slow devices may require
more than 1 stop bit.
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving
buffers are full, a ´stop´ signal can be sent to
stop the data flow. Once the buffers are empty,
a ´start 'signal can be sent to re-start the flow.
Hardware flow control uses two wires to send
start/stop signals.
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals.
On this mode enabled only text will be send.
This is to capture Terminal data.
Enables or disables extended terminal
resolution.
On Legacy OS, the Number of Rows and
Columns supported redirection.
Select FunctionKey and KeyPad on Putty.
The settings specify if BootLoader is selected
than Legacy console redirection is disabled
before booting to Legacy OS. Default value is
Always Enable which means Legacy console
Redirection is enabled for Legacy OS.
KTQM67 Users Guide

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ktqm67/flexKtqm67/atxpKthm65

Table of Contents