Siren Chir Ps On/Off (Programmable); Status Led Timer - Eaglemaster E5 G7 User Manual

- Siren chir ps ON/OFF (programmable):

This programme feature controls the chirps that confirm the arming , disarming and intrusion
alert of the system.
Note: Set siren chirp off, if door, hood or trunk not closed, siren will activated.
- Power disconnecting memor y :
Alarm is built in memory on main unit. Generally, after alarm power is cut off and reconnect,
main unit will read back these data make the alarm to resume.
- Red/black wire positive (+) programme input :
This wire Red/black is a (+) positive input can be controlled functions as : reverse
warning / Door lock / AV sw for 2nd step disarm .
Rever se waring:
If programmed with the feature, when you are reversing your car the parking lights will
flashing and siren will chirping (if programmed with siren) to prevent accident impacts to
animal or human body.
Note: you can proceed the Reverse warning without siren chirps : (1) when you activated
the Disarm w/o chirp before Ignition On. (2) when you reversing the Car simply press
the button
Door lock :
If programmed with the feature, doors will lock when activate this wire.
AV sw for 2nd step disar m:
If programmed with the feature, when disarming the system by the remote, however the
engine will still blocked, turn on the ignition the 2way will indicate flash icon
beep sound to indicate that the engine is blocked.
Exit: Turn ignition ON then press this AV switch once to release the start killer. This AV sw
can be installed any O/E switch as long as it (+) positive input.

- Status LED timer:

If the alarm system armed after 24 hours, the LED will blink shortly once per second.
Armed after 25~48 hours, the LED will blink shortly once every 3 seconds.
Armed after 48 hours, the LED will blink shortly once every 5 seconds.
-Horn pulse:
If programmed with Horn pulse output, for additional vehicle's horn honk output alert.
- Emergency reset switch: (for installer only)
If the remote has been lost or damage, or forgot the PIN code number the owner can enter the
car by using the key. It will act the alarm. To disarm the alarm by disconnect the system's power
, turn the Ignition to on and connect the "SW1" switch on the main unit pc-board , connect the
system's power, it will disarm the alarm immediately.
(Please ask your installer this "SW1" reset switch location).
Note: after this emergency reset activated, the PIN code will resumed factory setting
PIN code " 2 . 5 "
once.
and give