Eaglemaster E5 G7 User Manual page 30

2WAY Remote learning :
This system can expand 4 different transmitters, and comes from factory
with two transmitters already programmed into the system memory.
Whenever you want to add or delete transmitter code of the system, the
procedures are as following :
1. Disarm the system. Turn ignition switch to ON .
2. Within 10 seconds, press valet switch on-off for 5 times.
3. Siren/Horn will provide 1 long chirp to confirm the system is in code learning mode.
4.To press any remote button, code learning achieved if it gives one short chirp.
5.To turn off learning mode :
(1)Turn off ignition switch.
(2)Four transmitters have been successfully learnt already
(3) Within 10 seconds , there is no new transmitter be learnt.
Note: Every time learning new transmitter , formal code (old transmitter)
will be erased, hence you have to lean again .
PROGRAMMABLE FEATURE
Some of the operating settings of this unit are programmable. The
programmable mode setting dictates how the unit operates. It is possible to
access and change any of the feature settings using the Valet switch.
To enter the system programmable mode setting:
1. Disarm the system.
2. Ignition. Turn the ignition on, then back off.
3. Within 10 seconds, press Valet switch on-off for 5 times.
4. Siren will provide 2 short chirps follow with 1long chirp , to mean the system
entering programmable mode.
5. The times of Valet switch pressing is according to the function mode item number
and it will give chirp sound to indicate the function status. To judge it as per LED
indication (times of flashes).
- Short pulse flashes - indicates a digit in ones place.
- Long pulse flashes - indicates a digit in tens place.
5. To press the -
of the transmitter. You will hear 1, 2, 3, 4 siren chirps depending on the new
status of the function.
- To press the
will give short chirp to confirm the feature status.
6. Exit by: turning Ignition to OFF , the system will exit the programming mode and
siren will give two short chirps .
button : Change the status of the function by press the button
button : Confirm the feature status, press the button, siren