Eaglemaster E5 G7 User Manual page 29

FSK/868Mhz Antenna Call page :
FSK/868Mhz
Antenna module
Changing of the PIN code to turn off the system
This system provide 2 digit PIN code, each digit code can be programme from 1 to 9 , and
manufacturer code is ( 2.5). To program your new PIN code as follows:
1. Enter the system into the Valet mode .
2. Turn ignition switch from ON to OFF .
3. Within 10 seconds, press the Valet switch on-off for 5 times.
4. Siren/Horn will provide 2 long chirp to confirm the system is in PIN code setting mode.
<< Suppose that you want set new PIN code is 3.8 >>
5. To programme the 1st PIN code by press the Valet button the number of times
corresponding to the 1st digit of your PIN code. Press 3 times of the Valet button, (each
time the Valet button is pressing, the chirp sound will be given) .
6. Waiting 1sec. until the LED flash once. To confirm the 1st digit has been inserted.
7. To programme the 2nd PIN code by press the Valet button the number of times
corresponding to the 2nd digit of your PIN code. Press 8 times of the Valet button, (each
time the Valet button is pressing, the chirp sound will be given) .
8. Waiting 1sec. until the LED flash once. To confirm the2nd digit has been inserted.
9. It will give 2 chirp sound and then LED will notify the 2 digit PIN code, by 3 flashes -
pause - 8 flashes.
10. To Exit the mode, turn ignition to ON , or within 20sec. It will exit and in Valet mode.
Note:
Please notice that the time between your actions shall be less than 20 sec; otherwise the
system will automatically exit the programming mode .
The R.F antenna module provide a switch which can
be send a signal to the 2-way remote.
Call button
In disarmed or ACC on position, if press Call switch
for 2 seconds, lights will flashing 5 times and the
2-way remote will give pre-warn beep sound . The
vehicle page mode icon displays when the alarm
module is paging the transceiver.