Siren Chirps On/Off (Programmable); Status Led Timer; Power Disconnecting Memory; Emergency Reset Switch - Eaglemaster E5 Instruction Manual

- Siren chirps ON/OFF (programmable):

This programme feature controls the chirps that confirm the arming , disarming and
intrusion alert of the system.
Note: Set siren chirp off, if door, hood or trunk not closed, siren will activated.

- Status LED timer:

If the alarm system armed after 24 hours, the LED will blink shortly once per second.
Armed after 25~48 hours, the LED will blink shortly once every 3 seconds.
Armed after 48 hours, the LED will blink shortly once every 5 seconds.

- Power disconnecting memory :

Alarm is built in memory on main unit. Generally, after alarm power is cut off and reconnect,
main unit will read back these data make the alarm to resume. When in disarm, arm or
valet mode position, power off then on , alarm will read back original position.
Note: while power on of the system, the parking lights will flash twice for indication.
- Emergency reset switch: (for installer only)
If the remote has been lost or damage, or forgot the PIN code number the owner can enter the
car by using the key. It will act the alarm. To disarm the alarm turn ignition on and connect
"reset switch" for over 2sec. , it will disarm the alarm immediately. (Please ask your installer
this reset switch location).
Note: after this emergency reset activated, the PIN code will resumed factory setting
PIN code " 2 . 5 "
Emergency disarm (Valet SW & PIN code):
If the remote control has been lost or damaged, you can manually disarm your system by
programmed " Valet SW or PIN code":
Emergency disarm by Valet Switch :
(1) Turning the Ignition switch from OFF to ON position.
(2) Simply pressing and holding the Valet switch for over 3 seconds, the system will
disarmed immediately.
Emergency disarm by PIN code :
(The system's factory-set PIN code is "2 . 5" )
(1) Turning the Ignition switch from OFF to ON position.
(2) The LED will start flashing, the times of LED flashing is according to the 1st PIN code
numbers.
(3) While the LED flashing 2 times then turning the ignition switch to the OFF position, thus
the 1st PIN code has been inserted.
(4) Turn the ignition to ON again, the LED will start flashing again, while flashing 5 times
then turning the ignition the OFF position, thus the 2nd PIN code has been inserted.
(5) After 2 digit PIN code has been correctly inserted, the system will disarmed immediately
and siren will give 4-short chirps.
NOTE: Each cycle of alarm triggering is only provide one time to set PIN code, otherwise
the owner must wait next cycle triggering and then set PIN code again to disarm the system.
If the owner forgot the PIN code number, must use "Emergency reset switch " to reset the
alarm system (please see "Emergency reset switch" ).
-21-