Arm Without Siren Chirp; To Disarm The System; Intrusion Alert; Way Lcd Intrusion Alert - Eaglemaster E1 Plus Instruction Manual

- Arm without siren chirp :

To arm your system without siren chirp , simply press button
button once.
Note: this features is only activated under the system is in disarmed and Acc off position,.

- To DISARM the system :

To disarm your system within proper operating range, simply press button
system in arm position). The system will respond two siren chirp, two light flash, doors unlock,
Enable your engine starter, LED off.
2-way LCD display :

- Intrusion Alert:

Upon disarming the system, if the vehicle is attempted or intruded, siren and lights will Indicates
4 chirps and 5 flashes to identify which zone was triggered. LED mode indicates the following
different triggering.

- 2-way LCD Intrusion Alert:

Upon disarming the system, if the vehicle is attempted or intruded, the 2-way remote will respond
2 short beep follow with melody sound, and LCD display will indicates different icons as under:
1st-stage sensor
triggered
Trunk switch triggered
Note: Before the ignition turn on, you may realized again which zone been triggered by press
button (status check) once, the LCD will display triggered zone again.
flash 2 times after a pause
flash 3 times after a pause
flash 4 times after a pause
flash 5 times after a pause
flash 6 times after a pause
flash 7 times after a pause
2nd-stage sensor
triggered
Hood switch triggered
-7-
once then within 3sec. press
+ Two beep sound
Sensor 1st-stage triggered
Sensor 2nd-stage triggered
Door switch triggered
Trunk switch triggered
Hood switch triggered.
Ignition switch triggered.
Door switch triggered
Ignition switch triggered
once (while