Emergency Disarm (Valet Sw & Pin Code); Anti Car-Jacking Mode - Eaglemaster E5 G7 User Manual

Emergency disarm (Valet SW & PIN code):
If the remote control has been lost or damaged, you can manually disarm your system by
programmed " Valet SW or PIN code":
Emergency disarm by Valet Switch :
(1) Turning the Ignition switch from OFF to ON position.
(2) Simply pressing and holding the Valet switch for over 3 seconds, the system will
disarmed immediately.
Emergency disarm by PIN code :
1. Open the door with the key (the system will be triggered and ).
2. Turn on the ignition .
3. Press the Valet button the number of times which is in accordance with the first digit of
your PIN code (the manufacturer setting is 1 time). Each time the Valet button is
pressing, the LED will activated .
4. Waiting 1sec. until the LED flash once.
5. Press the Valet button the number of times which is in accordance with the second digit
of your PIN code (the manufacturer setting is 2 time). Each time the Valet button is
pressing, the LED will activated .
6. Waiting 1sec. until the LED flash once.
7. System will automatically disarmed and into the Valet mode.
Note:
If you enter the wrong code , turn off the ignition then start from step #2.

Anti Car-Jacking mode:

This feature will protect your vehicle in the event that there is an attempt to Hi-jack the
vehicle. The system provide 3 ways to activate the Anti car-jacking mode if programmed.
While system is trigger anti-car jack mode, lights will flash once and the LED will fast
flashing to show the system is enter anti-car jacking mode. see "anti-car jack mode table".
- Remote activates:
If programmed, to operate it when driving the car (ACC ON), press button
2sec. the parking lights will flash once and the LED will fast flash to show the system is
entering anti car-jack mode.
- Standby mode of door switch activates:
If programmed with the feature, to operate it when driving the car, press button
over 2sec., siren will give one chirp and the system now is in standby Anti car-jacking mode.
Under this standby mode, if a door is forced been open and close, the system will activate
Anti-car jack immediately. The parking lights will flash once to show the system is enter
anti car-jack mode.
EXIT: Under standby mode, you may exit this mode, if it is not activate the door, press
button for over 2 seconds, siren will give two chirps and LED off.
(The system's factory-set PIN code is "2 . 5" )
for
for