To Disarm The System; Intrusion Alert; Way Lcd Intrusion Alert - Eaglemaster E5 G7 User Manual

- To DISARM the system :

To disarm your system within proper operating range, simply press button
system in arm position). The system will respond two siren chirp, two light flash, doors unlock,
Enable your engine starter, LED off.
2-way LCD display :

- Intrusion Alert:

Upon disarming the system, if the vehicle is attempted or intruded, siren and lights will Indicates
5 chirps and 5 flashes to identify which zone was triggered. LED mode indicates the following
different triggering.

- 2-way LCD Intrusion Alert:

Upon disarming the system, if the vehicle is attempted or intruded, the 2-way remote will respond
2 short beep follow with melody sound, and LCD display will indicates different icons as under:
Zone1:1st-stage
sensor triggered
Door switch
triggered
Note: Before the ignition turn on, you may realized again which zone been triggered by press
button (status check) once, the LCD will display triggered zone again.
flash 2 times after a pause
flash 3 times after a pause
flash 4 times after a pause
flash 5 times after a pause
flash 6 times after a pa use
Flash 7times after a pause
Zone1:2nd-stage
sensor triggered
Trunk switch
triggered
Sensor 1st-stage tri ggered
Sensor 2nd-stage triggere d
D oor switch triggered
Trunk switch triggered
H ood switch tri ggered
Ig nition switch triggered
Zone2: 1st-stage
sensor triggered
Hood switch
triggered
once (while
+ Two beep sound
Zone2: 2nd-stage
sensor triggered
Ignition switch
triggered