Turbo Mode - Eaglemaster E5 G7 User Manual

- Turbo mode:

If programmed with the feature , this channel will constant output when ignition turn on for
over 1 minutes. It will keeps the engine running after arriving at your destination by ignition
off , the turbo will turn on and give a warning beep. This turbo time can be programme time
for 1, 3, 5, or 10 minutes. This allows the system's timer to conveniently cool down the
turbo after you have left the vehicle.
Run time icon will turn on 2sec. for programmed
alternate run-time and
Note: if turbo time's up , the icon will display
2-way LCD display :
Exit: You may disable this turbo mode at anytime, simply press button
turbo mode will stop immediately.
Note: in turbo mode time , if arming the system, sensors will be bypassed and Lights
flashing for a programmed turbo time.
- CH-6 (-) programme time output:
This channel-5 is a negative (-500mA) output features, this channel can be programmed
(1)- Arming output from 1~120sec.
(2)- Press button
(1)- Arming output 1~120sec. if programmed, this channel will activate when arming, the
output timing can be programmed from 1 to 120seconds.
(2)- Press button
button
Exit: When this channel is outputting, if press button
NOTE: This channel can be programmed pulse delay time (1~120sec.), If programmed,
channel-5 will delay output with programme pulse delay time.
, ,
give a warning beep .
Turn on icon
, output from 1~120sec.
output 1~120sec. If programmed, to operate this channel by press
for over 2sec. This channel will constant output for programme time.
). and then it will display every
current-time.
time of ( ,
2sec. of
, and
Flash icon
once, the
once, it will stop outputting.