Table of Contents
Advertisement
4.
Select Advanced > Security > Firewall Rules.
If you did not define any outbound rules, only the default rule is listed in the Outbound
Firewall Rules table. The default rule allows all outgoing traffic.
5.
Click the Add button.
6.
In the Services list, select the service.
If the service is not in the list, select User Defined. If you select User Defined, you must
select the protocol and enter the name and the range of port numbers used by the
service. For services on the list, these fields are filled in automatically.
7.
In the Action list, select a block or allow setting.
8.
To block specific LAN users, in the LAN Users list, select Single Address or Address
Range and type the IP address or addresses.
9.
To block specific WAN servers, in the WAN Services list, select Single Address or
Address Range and type the IP address or addresses.
10.
To log instances of when this rule is used, in the Log list, select Always.
11.
Click the Apply button.
Your settings are saved. The Firewall Rules screen displays the new rule.
Dual Band Wireless VDSL2 + Ethernet Gateway
Control Internet Access
42
Advertisement
Table of Contents
