NETGEAR VEVG2610-1FXAUS User Manual page 30

The IPv6 screen displays.
5. In the Internet Connection Type list, select PPPoE.
The screen adjusts:
The gateway automatically detects the information in the following fields:
• Router's IPv6 Address on WAN. This field shows the IPv6 address that is acquired
for the gateway's WAN (or Internet) interface. The number after the slash (/) is the
length of the prefix, which is also indicated by the underline (_) under the IPv6
address. If no address is acquired, the field displays Not Available.
• Router's IPv6 Address on LAN. This field shows the IPv6 address that is acquired
for the gateway's LAN interface. The number after the slash (/) is the length of the
prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
6. In the Login field, enter the login information for the ISP connection.
This is usually the name that you use in your email address. For example, if your main
mail account is JerAB@ISP.com, you would type JerAB in this field. Some ISPs (like
Mindspring, Earthlink, and T-DSL) require that you use your full email address when you
log in. If your ISP requires your full email address, type it in this field.
7. In the Password field, enter the password for the ISP connection.
8. In the Service Name field, enter a service name.
If your ISP did not provide a service name, leave this field blank.
Note: The default setting of the Connection Mode list is Always On to
provide a steady IPv6 connection. The gateway never terminates the
connection. If the connection is terminated, for example, when the
modem is turned off, the gateway attempts to reestablish the
connection immediately after the PPPoE connection becomes
available again.
Dual Band Wireless VDSL2 + Ethernet Gateway
Internet Setup
30