Replacing The Controller Module - Uniwide AR3016G Hardware User's Manual

AR3016G Installation and Hardware Reference Manual
Figure 5-1: Removing Screws from the Retention Levers
Step 4. Remove the controller module by pressing down the two (2)
Step 5. Gently pull the controller module out of the subsystem. Place the

5.2.4 Replacing the Controller Module

If the controller module itself has failed, it must be replaced. To replace a
failed controller module:
Step 1. Remove the controller module from the subsystem (see Section
Step 2. Install the DIMM module onto the new controller module;
Step 3. Install the controller module. Make sure the levers at the back of
5-4
levers at the back of the controller module. The controller module
will automatically be eased out of the controller module bay. (See
Figure 5-2)
Figure 5-2: Removing the Controller Module
controller module on a clean surface.
5.2.3) If the DIMM module is undamaged, it can be removed and
reinstalled on the new controller module. For instructions on
removing and installing a DIMM module, please see Section 5.3)
making sure that the memory module is securely in place. (See
Section 5.3)
the controller module are down. Align the controller module with
the controller module bay at the rear of the subsystem. Gently
slide the controller module in. (See Figure 5-3)
Replacing Controller Module Components