Table of Contents
Advertisement
AR3016 Installation and Hardware Reference Manual
4
5
6
This controller module has additional four (4) LEDs, labeled Link and
Speed. The definitions of these LEDs are shown in Table 3-5 below.
LED
Link
Speed
3.2.5 LAN Port LEDs
A shielded Ethernet cable must be used to connect the RJ-45 Ethernet port
to a hub on a network after you assign a permanent IP to the AR3016G. This
enables you to manage your subsystem via the web. Two (2) LEDs located
on the Ethernet port indicate the Ethernet connection status. See Figure 3-4
for the locations of the two (2) LED indicators. Refer to Table 3-6 for the
LED definitions.
3-6
BBU Link
Green
Green
Hst Busy
Drv Busy
Green
Table 3-4: Controller Module LED Definitions
Name
Color
Green
CH0/1 Link
CH0/1 Speed
Green/
Amber
Table 3-5: Controller Module Channel Status LEDs
Online Status
Figure 3-4: LAN Port LEDs
ON indicates the BBU is present. The
BBU is able to sustain the cache
memory.
FLASHING indicates there is activity
on the host ports.
OFF indicates there is no activity on
the host ports.
FLASHING indicates there is activity
on the drive ports.
OFF indicates there is no activity on
the drive ports.
Status
ON indicates that channel 0/1 link has
been established.
OFF indicates that channel 0/1 link has
not been established.
LIT GREEN indicates 4G link Speed
FLASHING AMBER indicates 2G
link Speed
OFF indicates 1G link Speed
LAN Activity
Status-indicating LEDs
Advertisement
Table of Contents
