Sata Drive Installation; Drive Tray Installation - Uniwide AR3016G Hardware User's Manual

AR3016G Installation and Hardware Reference Manual

2.8.2 SATA Drive Installation

Step 1. Place the SATA hard drive into the drive tray (as shown in
Step 2. Adjust the drive's location until the mounting holes in the drive

2.9. Drive Tray Installation

Once the hard drives have been installed in the drive trays, the drive trays
must be installed into the AR3016G.
All drive trays must be installed into the enclosure even if they do not
contain a hard drive. If the trays are not installed into the enclosure, the
ventilation required for cooling will not be normalized and the subsystem
will overheat.
Step 1. Make sure the Carrier is right position.
Step 2. Open the front flap on the drive tray (see Figure 2-7) by
2-10
Figure 2-5), making sure that the connector at the back of the
drive is facing the back of the drive tray.
Figure 2-5: Insert the Hard Drive and the Retention Screws
canister are aligned with those on the hard drive. Secure the drive
with four supplied 6/32 flat-head screws. (See Figure 2-5)
WARNING!
Figure 2-6: Front View of an Individual Drive Tray
pushing the release button on the front of the drive tray. The front
flap will open in an upward direction.
Drive Tray Installation