Table of Contents
Advertisement
Step 3. Align the drive tray with the slot in which you wish to insert it.
Step 4. Close the front flap on the drive tray. Make sure the front flap is
Step 5. Once the drive tray is inserted, the RAID controller will
Drive Tray Installation
Figure 2-7: Open Drive Tray Front Flap
Make sure that it is resting on the rails inside the enclosure, and
then gently slide it in. This should be done smoothly and gently.
Figure 2-8: Installing a Drive Tray
closed properly to ensure that the connector at the back of the
hard drive is firmly connected to the corresponding connector on
the backplane board. If the front flap is not closed properly, the
connection between the hard drive and the subsystem will not be
secure.
Figure 2-9: Closing the Drive Tray Front Flap
recognize the drive and scan it in automatically.
Chapter 2: Hardware Installation
2-11
Advertisement
Table of Contents
