Table of Contents
Advertisement
AR3016G Installation and Hardware Reference Manual
1.2.2 Drive Trays
PN: IFT-9273CDTray
Each AR3016G subsystem comes with sixteen (16) drive trays. The front
panel of each drive tray (see Figure 1-7) contains a locking mechanism that
secures the drive tray to the enclosure and a latch that facilitates the removal
and installation of the drive tray. Two (2) status-indicating LEDs are also
located on the front of the drive tray. Retention screw holes are located on
the sides of the drive tray. These holes are reserved for securing hard drives
to the tray. Other retention screw holes are located on the surface of the tray
at the rear.
Be careful not to warp, twist, or contort the drive tray in any way (e.g., by
dropping it or resting heavy objects on it). The drive tray has been
customized to fit into the drive bays in the ES subsystem. If the drive bay
superstructure is deformed or altered, the drive trays may not fit into the
drive bay.
1.2.3 RAID Controller Modules
Part Number: IFT-83AF24GE16
The RAID controller module that shipped with your subsystem contains a
metal bracket, a main circuit controller board, a management rear panel, and
a pre-installed 256MB capacity or above DDR RAM DIMM module. (See
1-6
Figure 1-7: Drive Tray
WARNING!
Figure 1-8: Controller Module
AR3016G Components
Advertisement
Table of Contents
