Table of Contents
Advertisement
group
To configure SNMP group, the command adds an SNMPv3 group entry.
Syntax
group <user name> <security model> <group name>
Parameter
< user name > The name of user connecting to the SNMP agent. (Range: 1-32
characters, ASCII characters 33-126 only).
< security model > The user security model. (1|2|3), 1 is (v1), 2 is (v2c), 3 is
(usm).
<group name > The name of the SNMP group. (Range: 1-32 characters, ASCII
characters 33-126 only).
EXAMPLE
mode
To enable or disable the SNMP mode.
Syntax
mode <disable/enable>
Parameter
< disable > Disable SNMP mode.
< enable > Enable SNMP mode.
N
:
OTE
An SNMPv3 group sets the access policy for its assigned
users, restricting them to specific read and write views as
defined by the access entry. You can use the pre-defined
default groups, or create a new group and the views
authorized for that group.
Note that the views assigned to a group must be
specified with the view entry.
v1 : Up to 2 group names can be configured.
V2 : Up to 2 group names can be configured.
usm : Up to 10 group names can be configured.
Advertisement
Table of Contents
