Table of Contents
Advertisement
40
SNMP of CLI
Table : SNMP Commands
Command
access
community
delete
engine-id
group
mode
show
trap
user
view
access
To configure the SNMP access, the command adds an SNMPv3 access
entry.
Syntax
access <group name> <security model> <security level> <read_view name>
<write_view name>
Parameter
< group name > The name of the SNMP group. (Range: 1-32 characters, ASCII
characters 33-126 only).
< security model> The user security model (Range 0 to 3). Security Model:
1(v1), 2(v2c), 3(usm), 0(any).
< security level> The security level assigned to the group (Range 1 to 3),
1(NoAuthNoPriv), 2(AuthNoPriv), 3(AuthP iv). If security model is not usm,
the security_level value must be 1(NoAuthNoPriv).
<1-NoAuthNoPriv> => There is no authentication or encryption
used in SNMP communications.
<2- AuthNoPriv > => SNMP communications use authentication,
but the data is not encrypted.
<3- AuthPriv > => SNMP communications use both authentication
and encryption.
< read_view name> The scope for a specified instance can read, None is
Function
Configure SNMP access
Configure SNMP community
Delete command
Set SNMP Engine ID
Configure SNMP groups
Enable/Disable SNMP mode
Show SNMP command
Configure SNMP trap
Configure SNMP users
Configure SNMP views
Advertisement
Table of Contents
