Table of Contents
Advertisement
<trap port> To set the trap port, the available value is from 1 to 65535.
<severity level> To configure the Severity level, the available value is from 0 to
7.
<0> Emergency: system is unusable.
<1> Alert: action must be taken immediately.
<2> Critical: critical conditions.
<3> Error: error conditions.
<4> Warning: warning conditions.
<5> Notice: normal but significant condition.
<6> Informational: informational messages.
<7> Debug: debug-level messages.
<security name> Specifies the community access string to use when sending
SNMP trap packets. (Range: Range: 1-32 characters, ASCII characters 33-126
only).
<security level> The security level assigned to the user(1|2|3)
1=> NoauthNoPriv.
2=> AuthNoPriv.
3=> AuthPriv.
< Authentication protocol > The method used for user authentication(1|2)
1=> MD5.
2=> SHA.
< Authentication password > Authentication Password is restricted to 8 - 40.
EXAMPLE
user
To configure SNMP users, the command adds an SNMPv3 user entry.
Advertisement
Table of Contents
