Oil Pump Assembly - PGO G-MAX 50 Service Manual

8.Remove oil pump separate plate by
taking off the 2 bolts.
9.Remove the bolts from oil pump
driving gear
10.Take off the driving gear and chain.
11.Remove the oil pump by taking off
the locking bolt of the oil pump.

Oil pump Assembly

1.Install the inner and outer of the oil pump.
2.Install the oil pump shaft.
Note:
The notch of the oil pump shaft should comply
With the notch of the inner gear.
3.Install the lock pin.
4.Match the lock pin hole to the pump cover
and install the oil pump cover.
5.Put on the screws and tighten them.
6.After installing, turn the shaft lightly
to assure installation.
7.Place the oil pump into the crankcase.
Note:
When installing, the arrow on the oil pump
body should be pointed upwards. Then fill in
the recommended oil before the installation.
8.Tighten the oil pump after installation.