Testing The Recharging Performance - PGO G-MAX 50 Service Manual

3.Testing the recharging performance

This test needs to be done when the battery is fully recharged.
This test needs to be done after engine is warm-up.
a. Disconnect the orange cable of regulator.
b. Open the fuse box, to remove the white cable.
c. Connect currency meter between red/white cable and fuse.
While testing, the red wire cable must not touch the frame.
d. Set the head lamp switch at "OFF", engine revolution is at 2000 rpm while testing.
Then increase the rpm slowly. (Assume the battery is fully charged. situation)
Head Lamp Switch
OFF(DAY)
ON(NIGHT)
e. If the testing result does not match the standard value, check the regulator.
Recharging rpm
Under2,000rpm
Under2,000rpm
2,500rpm
0.6A(MIN)
0.6A(MIN)
6,000prm
1.5A(MIN)
1.5A(MIN)