PGO G-MAX 50 Service Manual page 66

E. Clutch driven pulley
1.Dismantle the clutch
a. Remove left crankcase cover.
b. Remove driving plate.
c. Remove driving belt.
d. Remove the M10 locking nut, then the clutch.
2.Assembling the clutch: please follow the opposite procedure of dismantling.
Locking torque:
M10: 3.5~4.0kg-m
3.Checking the clutch:
Dismantling the clutch needs the special
Tool. please contact your dealers.
a. Check the clutch driven face.
Check the clutch cover about its wearing
Condition and inner diameter measurement.
Limit of use:
50cc:Change it when above 117.5mm
b. Check the clutch lining wearing condition
and measure the lining thickness
limit of use:change it below 2.5mm.