Hangar 9 Ultra Stick 60 Instruction Manual page 71

Section 19:
Programming Guide — JR 10X/10SXII/10SX
Indicates program Switch or stick position where mixing
values will become active. All except
being accessed
FIX will have a 0 and a position 1
Elevator is the
master channel,
Flap is the slave
Switch or stick position where mixing
values will become active. All except
FIX will have a 0 and a position 1
Touch
Indicates program
proceed to other
being accessed
mixing screen
Offset value Touch to
store offset or
Aileron is the
basic mixing point
master channel,
Refer to offset
Flap is the slave
operation
* Flap Switch
UP = Normal
MID = Takeoff flaps
DOWN = Crow
Shaded box indicates
value being adjusted
Indicates
Touch the
direction of mix
keys to alter mixing
value
Mixing
Touch to
change mix direction percentage
value
Refer to mixing
value and directions
Shaded box indicates
value being adjusted
to Touch to
memorize and exit
program
Indicates
Touch the
direction of mix
keys to alter mixing
value
Mixing
Touch to
percentage
change mix direction
value
Refer to mixing
value and directions
Step 10. Programmable mix for elevator-to-flap, Code 52:
Enter Code 52, Programmable Mix 2, and press the "3" key and
then the "6" key to select the ELEVATOR as master and the
FLAPS as slave channels. Press Enter, then press the Page key
to select the switch screen. Below MX press the SEL key to
select the mix switch to operate the mix. This will allow the
elevator-to-flap mix to be turned on/off using the mix switch.
Press the Page key twice to return to the mix screen. With the
mix switch (back right side of transmitter) in the forward position,
hold up elevator and press the (+) key until the flaps go down.
If the flaps go in the wrong direction, press the Turn key. Mixing
percentage value of 35% is a good place to start. Now with
down elevator, press the (+) key until the flaps go up. Also use
35% as a starting point here. Later you can adjust these values
to suit your flying style.
Step 11. Programmable mixing of aileron-to-flaps, Code 53:
Enter "Code 53, Programmable Mix 3." Press the "2" key and
then the "7" key to mix aileron to AUX 2, then press Enter.
Press the Page key to access the switch select screen and press
the SEL key below MX. This will turn on/off the aileron-to-flap
mix with the mix switch (located at the back left of the transmitter).
Press the Page key twice to return to the "Programmable Mix 3"
screen. With the mix switch in the forward position, press the (+)
key while holding the right aileron control stick until the value
reads 100%. If the flap moves opposite the aileron, then press
the Turn key. Now holding left aileron with the control stick, press
the (+) key until 100% is achieved. Press the Turn key if necessary.
* Mix Switch = Turns on/off aileron-to-flap
CONTINUED
and elevator-to-flap mixes
71