Table of Contents
Advertisement
Section 19:
Programming Guide — JR 10X/10SXII/10SX
Indicates current wing
Indicates the aileron
type selection
dif ferential percentage
Indicates function
Indicates the aileron
being programmed
differential direction
Touch
to
advance to next
wing type selection- NORMAL
Indicates feature
Arrow indicates
being programmed
control selected
Touch
to select the
control you wish to inhibit or
activate
Indicates which code
is being programmed
Denotes travel direction
(
If upper area is
NOTE:
shaded, travel is reversed;
If lower area is shaded,
then travel is normal.)
Channel (servo)
Indicates function
Touch
being programed
other five channels
Touch
to
Touch
to
increase
decrease
trim value
trim value
Offset value ±
Touch
to allow each
direction of travel adjust
to be set individually
(10X only)
Channel
(servo)
Touch the
to
Touch the
increase travel
decrease the
adjust for shaded
travel adjust for
area (0-150%)
the shaded area
(0-150%)
Touch
to exit program
Press
or
to clear or activate the
selected control
Depiction of servo
travel direction
Touch
memorize data
and exit program
Respective
channel number.
Touch to reverse
servo travel direction
to display
Touch
to
access the next
five channels
to
Touch
simultaneously, or
press
to reset the
CL
shaded area to 100%
factory default
Step 2. Wing Type, Code 22: Enter Code 22 and below
normal press the SEL key until QUAD.FLP appears. Press Enter
to return to the Function mode screen.
Step 3. Turn off unused channels, Code 17: Enter Code 17
and inhibit channels 5 through 10 by pressing the SEL key to
select each channel, then press the Clear key to inhibit each channel.
Step 4. Set the servo reversing, Code 11: Enter Code 11
and check that the direction of each servo is moving properly.
Reverse any servo as necessary by pressing the numbered key
to
that corresponds with that channel.
1 — Throttle
2 — Right Aileron
3 — Elevator
4 — Rudder
5 — Left Aileron
6 — Right Flap
7 — Left Flap
Step 5. Sub-Trims, Code 15: Turn on the transmitter and
receiver and center the trims on the transmitter. Reposition any
of the control arms as necessary such that the control surfaces
are as close to neutral as possible. Now enter "Code 15,
Sub-Trim" and fine adjust each control surface until it's perfectly
neutral using the (+) or (-) keys below each corresponding
channel. The Page key allows access to the other five channels.
Pressing Enter will return to the Function mode.
Step 6. Travel Adjust, Code 12: Enter Code 12 and adjust
the control travels of each control surface to the following using
the (+) or (-) key below each channel. Pressing the PAGE key
will access the other five channels.
Throttle — Full open to full closed with trim
Aileron — 1
1
/
" up, 1
4
Elevator — 1
1
/
" up, 1
2
Rudder — 4" right, 4" left
CONTINUED
1
/
" down
4
1
/
" down
2
69
Hide quick links:
Advertisement
Table of Contents
