Hangar 9 Ultra Stick 60 Instruction Manual page 62

Section 19:
Programming Guide — JR XP8103
Current Flap Channel Input
Pot 6: Flap Knob
FLP.SW+PG: Flap Switch and Pot 6
Step 4. Assigning the flaps to the flap switch: In System
Setup Mode press the Up key until "Input Sel." (Flap Input)
Step 5. Setting servo reversing: Turn the transmitter off
and then back on again. Press the Up and Down keys simultane-
ously to access the Function mode. Press the Up key until the
"REV.SW" function appears on the screen. Press the Channel
key to select each channel and check that the servo direction is
operating correctly for each channel. To change the direction of
the selected channel, press the (+) or (-) key. Check and adjust
all channels as necessary.
62
UP DN SELECT CH
UP DN SELECT CH
Channel Selection
(1-8)
CH CLEAR
Press to reset Flap
Press either the (+) or (-)
input to Pot 6.
key to select Pot 6 or
FLP.SW +P6.
appears on the screen. Press the (+) key so that "FLP.SW+P6"
appears in the lower screen.
Channel Being Programmed
SPOI Throttle
AIL1 Aileron Right
ELEV Elevator
RUDD Rudder
AIL2 Aileron Left
FLAP Flap (Right)
AUX2 Flap (Left)
AUX3 Extra Channel (Aux3)
CH CLEAR
Reset travel direction to
Use + or -
factory preset (normal)
to change
(normal/reverse)
Note: When the three-position flap switch is pulled down,
the flap should come down. If they go up, reverse the
direction of channel 6 (FLAP) and or 7 (AUX 2).
Note: Because the GLID model programming is being
used, the transmitter refers to the throttle function as
SPOI or spoilers. Any time "SPO"I is displayed, it functions
as throttle.
CONTINUED