Hangar 9 Ultra Stick 60 Instruction Manual page 12

Section 2:
Joining the Wing Halves
Step 6. Place one wing half right side up on a flat work surface.
Note: It's helpful to put wax paper under the wing.
Using an epoxy brush, smear a generous amount of epoxy into
the wing joiner cavity in the wing panel.
Step 7. Coat one half of the wing joiner with epoxy up to the
pencil line drawn in Step 1. Install the epoxy-coated half of the
wing joiner into the wing joiner cavity up to the marked center-
line. Any excess epoxy can be cleaned up with rubbing alcohol
and paper towels.
Note: You will need to mix an additional 1-2 ounces of
epoxy to complete the wing joining process
12
Step 8. Apply a generous amount of epoxy into the wing joiner
cavity of the other wing panel.
Step 9. Install a T-pin into the wing joiner at the center mark.
This will allow you to keep the brace "in the center" of the wing
when joining the two wing halves. Next, apply epoxy to all sides
of the exposed area of the wing joiner and uniformly coat both
wing roots with epoxy.
CONTINUED