Section 11: Assembling The Fuel Tank - Hangar 9 Ultra Stick 60 Instruction Manual

Section 11:
Assembling the Fuel Tank
Items Needed
Parts Needed
Metal tubes (2)
Clunk (fuel pickup)
Fuel pickup tubing
Fuel tank
Step 1. Locate the tank parts.
Note: The stopper provided with the Ultra Stick
three holes that are not completely through the stopper.
You will only be using two holes: one for the fuel pickup
and one for the fuel vent. Make sure not to open the third
hole, as this will cause a fuel leak.
Step 2. Locate the rubber stopper. Insert the short brass fuel
tube into one of the holes in the stopper so that an equal amount
of tube extends from each side of the stopper. This tube will be
the fuel tank pickup that provides fuel to the engine.
Metal caps (2)
Rubber stopper
3mm screw
™ 60 has
Tools and Adhesives Needed
Hobby knife
Medium screwdriver
Step 3. Slide the smaller of the two caps over the tube on the
smaller end of the rubber stopper. The small end will be inserted
into the fuel tank. The larger cap is placed on the other side of
the rubber stopper that makes the cap. Insert the 3mm screw
through the large cap and rubber stopper. Loosely thread the
screw into the small cap as shown.
Step 4. Locate the longer brass fuel tube and bend it using your
fingers as shown. This will be the fuel tank vent tube.
31