Hangar 9 Ultra Stick 60 Instruction Manual page 50

Section 19:
Programming Guide — JR XP652/642
Press the MODE button
until "MIXALL" appears
Step 8. Mixing elevator-to-flaps: Press the Mode key until
the "MIX A11" screen appears. This is programmable MIX A and
it allows you to mix any channel to any other channel or even to
itself. Press the Channel key until the "MIX Ach" appears. This
screen will allow you to select the master (elevator) and slave
(in this case GEAR because GEAR is being used to deploy flaps).
Elevator is channel 3, so press the Increase key until the screen
reads "31." The first digit (3) is now the master channel
(elevator). Now press the Decrease key until "35" appears in the
screen. The second digit (5) is now the slave channel (gear,
which we have Y-harnessed to flaps). This gives us an elevator-
to-flap mix. Press the Channel key twice until "0%" appears on
the screen. Now hold up elevator and press the Increase key
until 35% is achieved. An up elevator command should result in
Step 9. Crow mixing: We've already done
crow mixing above when we activated the flaperons and adjusted
the ailerons to go up when the flap switch is pulled in Steps 2
and 5. Now we need to add down flaps and some down elevator.
To get down flap when the flap switch is pulled, we're going to
mix flap as master to gear as slave. Press the Mode key until
"MIXB11" appears on the screen. Now press the Channel key to
Step 10. Elevator Offset: To set the necessary down elevator
with crow, press the Mode key until "OFFSET F-E" appears on
50
ENTER
MODE CHANNEL
on the screen.
ENTER
MODE CHANNEL
1
/ of the work in
3
F - E
OFFSET
0
ENTER
MODE CHANNEL
Press the MODE button
until "OFFSET F-E" appears
on the screen.
+ –
CLEAR
INCREASE DECREASE
the flap going down. If the flaps go up instead, this 35% value
needs to be -35%. Press the Decrease key until -35% is
achieved. Now holding down elevator, press the Increase or
Decrease key so that the flap goes up 35%.
Note: It's possible to assign this mix to be turned off/on
using a selected switch. Press the Channel key until "MIX-
ASW" appears. Pressing the Increase key will allow you to
assign this mix:
F1 = flap switch
A = aileron dual rate switch
E = elevator dual rate switch
ON = always on.
+ –
CLEAR
INCREASE DECREASE
access the "MIXBch" screen. Press the Increase key until "61"
appears, then press the Decrease key until "65" appears in the
screen. This programs channel 6 (flaps) as master and channel
5 (gear) as slave. Now press the Channel key until "MIX65 0%"
appears on the screen. With the flap switch pulled forward, press
the Increase key or Decrease key until the flaps go down 1
INDICATES FLAP TO ELEVATOR
OFFSET TRIM FUNCTION
ELEVATOR OFFSET VALUE (±125)
+
INCREASE
Press the INCREASE or DECREASE
button to adjust the flap elevator
the screen. With the flap switch in the forward position, press
the Increase or Decrease key until the elevator goes down 5/8."
CONTINUED
CURRENT MIX
A 3 5
MIX
CYRRENT MIX
3 5
% CHANNELS
CURRENT MIX
B 6 5
MIX
CURRENT MIX
2 7
CHANNELS
%
–
CLEAR
DECREASE
offset value.
1 / ."
2