Jrxp783/Xp347/Xp388S - Hangar 9 Ultra Stick 60 Instruction Manual

Section 19:
Programming Guide — JR XP783/XP347/XP388S
Programming Your JR XP783, XP347 and XP388S in 14 Easy Steps
JR's XP783, XP347 and XP388S all feature the same base level
programming, so the procedure for setting up quad flaps for
each radio is identical.
Note: Most of the quad flap features needed for the Ultra
Stick are already preprogrammed in the glider (referred to
as GLID) software included in these three radios. While
the Ultra Stick ™ 60 is not a glider, there are several built-in
When setting up a new aircraft, it's important to reset the
programming to the factory defaults.
UP
Step 1. Resetting the programming to factory defaults:
Hold down both the Up and the Down keys simultaneously and
turn on the radio to enter System Setup mode. Now press the
52
4N600
JAPAN REMOTE CONTROL CO., LTD.
Pulse Code Modulation
NEW ABC & W SYSTEM
9 CHANNEL RECEIVER
NER-649S
72 MHZ
JAPAN REMOTE CONTROL CO. LTD
MADE IN JAPAN
NER-649S
S-PCM Receiver
JRPR649
M D L . 1
Model No. to be Reset
DN CH
features in the glider programming that make quad flap
easier to program and use. We strongly suggest using
the GLID model type programming that's included in
these radios.
First, it's important to plug each servo into the correct port in
the receiver.
®
Receiver Battery
4.8V 600mAh
BATT
AUX 4
AUX 3
AUX 2
AUX 1
GEAR
RUDD
ELEV
AILE
THRO
RSET
Function Being Programmed
+
Up key until "RSET" (reset) appears on the screen. Pressing the
CLR key will reset the programming to the factory defaults.
Not Used
Not Used
Auxiliary 2/Flap (left)
Auxiliary 1/Flap (right)
Aileron (left)
Rudder
Elevator
Aileron (right)
Throttle
–
CLR
Data Reset Key