Hangar 9 Ultra Stick 60 Instruction Manual page 29

Section 9:
Installing the Rudder and Elevator Control Horns
Step 4. Using the screws and backplate provided, attach
the elevator control horn and fasten in place with a Phillips
screwdriver.
Step 5. Measure 1" up from the bottom of the rudder on the left
side. Mark the location with a felt-tipped pen or pencil. This
mark will be the center of the rudder control horn.
Step 6. Center the control horn over the mark you've just made.
Make sure the horn is positioned over the hinge line, just like
you did for the elevator. Using a felt-tipped pen or pencil, mark
the mounting hole locations onto the rudder.
Step 7. Drill these holes with a 1/16" drill bit and install the
rudder control horn, using the screws and backplate provided.
CONTINUED
29