Hangar 9 Ultra Stick 60 Instruction Manual page 54

Section 19:
Programming Guide — JR XP783/XP347/XP388S
AILE : Aileron (Right Aileron)
ELEV : Elevator
SPOI: Throttle
RUDD : Rudder
AILE: Aileron (Right Aileron 1)
GEAR : Gear (Left Aileron – Aileron 1)
ELEV: Elevator
AUX1 : Auxiliary 1
AIL2: (Right Flap Channel for Dual Flaps) Left Aileron
AUX2 : Auxiliary 2
FLAP: Right Flap
(Left Flap Channel for Dual Flaps)
AUX2: Left Flap
UP
Step 5. Setting servo reversing: Turn the transmitter off,
then back on again. Press the Up and Down keys simultaneously
to access the Function mode. Press the Up key until the "REV"
function appears on the screen. Press the Channel key to select
each channel and check that the servo direction is operating cor-
rectly for each channel. To change the direction of the selected
channel, press the (+) or (-) key. Check and adjust all channels
as necessary.
UP
Step 6. Turning off the trim knobs: In Function mode,
press the Up key until the "POT.5 TRIM" screen appears.
Pressing the CH key will advance through the three available
trim pots: 5, 6, and 7. Inhibit all three by pressing the (+) key
54
Function Being Programmed
REVERSE SW
R U D D
Channel Display
DN CH
Channel Selection
P O T . S
Trim Display
PO T.5 : Flap Trim of Flaperon
POT.5: Flap Trim of Flaperon
PO T.6 : Dual Flap's Flaptrim
POT.6: Dual Flap's Flaptrim
(Only if Dual Flap is Active)
POT.7: Dual Flap's Aileron Trim
POT .7 : Dual Flap's Aileron Trim
(Only if Dual Flap is Active)
DN CH
Trim Display
Selection
NORM
Setting Condition
NORM : Normal
REV : Reverse
+
Travel Direction Selection
Note: When the three-position flap switch is pulled down,
the flap should come down. If they go up, reverse the
direction of channel 6 (AUX 1) and/or 7 (AUX 2)
Note: Because the GLID model programming is being
used, the transmitter refers to the throttle function as
SPOI or spoilers. Any time "SPOI" is displayed, it functions
as throttle.
TRIM
Setting Operation
TRIM : Trim Operation
IN H : Inhibited
+
Reverse Current Function
Setting Operation
when each one is selected. This will prevent any unwanted
control movement should the knobs be moved.
Note: With the 347, POT.6 is not available.
CONTINUED
–
CLR
Resets Travel Direction
to Normal
–
CLR
Function Reset to Trim