Hangar 9 Ultra Stick 60 Instruction Manual page 49

Section 19:
Programming Guide — JR XP652/642
Note: The dual rate switch position
is changed/accessed by setting the
appropriate dual rate switch to the 0
or 1 positions.
Step 6. Adjusting the dual rates: Press the Mode key until
the dual rate screen appears. The Channel key allows you to
select the aileron or elevator channel while the respective dual
Note: The dual rate switch position is
changed/accessed by setting the appropriate dual
rate switch to the 0 or 1 positions.
ENTER
MODE
Press the MODE
button until "EXP"
appears on the
left side of the
screen.
Step 7. Using exponential: Exponential is used to reduce
the sensitivity of control around center while still providing
full control authority when the control stick is fully deflected.
Because the Ultra Stick uses large control throws, it's a good
idea to give Expo a try, even if you've never used it before, to
help prevent over-controlling. Press the Mode key until "EXP"
appears on your screen. Use the Channel key to select the
INDICATES THE DUAL RATE FUNCTION
CHANNEL
AI : AILERON
EL : ELEVATOR
A I O
D/R
I00
%
ENTER
MODE CHANNEL
Press the MODE Press the
button until "D/R" CHANNEL button
appears on the until "AI" or "EL"
screen. appears on the
screen.
CHANNEL
Press the CHANNEL
button to select either
aileron or elevator
exponential.
SWITCH POSITION (0 OR 1)
DUAL RATE VALUE (0–125%)
+
CLEAR
INCREASE DECREASE
Press the INCREASE or DECREASE
button to adjust the dual rate value.
rate switch allows you to select position 0 or 1. Adjust the high
rate to 100% and the low rate to 50% using the Increase and
Decrease keys. First flights should be attempted on low rates.
A I O
SWITCH POSITION
AI = AILERON
0
%
EXP
EL = ELEVATOR
EXPONENTIAL VALUE
+ –
CLEAR
INCREASE DECREASE
Press the (+) and (-) buttons to
increase/decrease the
exponential valve (0–100%).
aileron or elevator channel, then use the dual rate switch to
access position 0 or 1. Separate expo values can be pro-
grammed for position 0 and 1. Press the Increase or Decrease
keys to program the desired expo value for the selected channel
and switch position. We recommend starting with an expo value
of 25% on elevator and 30% on ailerons then, on subsequent
flights, adjust the value until the desired control feel is achieved.
CONTINUED
–
49