Troubleshooting Guide - Speck pumps EasyFit 1.65 THP Installation, Operation And Service Manual

v
14

Troubleshooting Guide

Diagnosing certain symptoms may require close interaction with, or in close proximity to,
components that are energized with electricity. Contact with electricity can cause death,
personal injury, or property damage. When trouble shooting the V-Green 165, diagnostics
involving electricity should be cared for by a licensed professional.
Symptom Possible Causes
Controller DIP switches not
configured properly
V-GREEN 165
Mains Voltage is not present
FAILS
TO START
User Interface is not connected
V-Green 165 shaft is locked
V-Green 165 shaft is damaged
V-GREEN 165
Over temperature FAULT
RUNS
THEN
Over current FAULT
STOPS
Debris in contact with fan
V-GREEN 165
IS
Debris in strainer basket
NOISY
Loose mounting
Impeller is loose
V-GREEN 165
RUNS,
Air leak
BUT NO
FLOW
Clogged or restricted plumbing
Potential Solutions
Verify that the DIP switches of SW100 un-
der the controller terminal box cover are
in the correct position. Refer to section 10.
Replace fuse, reset breaker/GFI.
Tighten mains wire connections.
Check connections at J201 connector.
Check if the V-Green 165 can be rotated
by hand and remove any blockage.
Replace V-Green 165.
Check that back of V-Green 165 is free
from dirt and debris. Use compressed air
to clean.
V-Green 165 will automatically restart
after one (1) minute.
Check that back of V-Green 165 is free
from dirt and debris. Use compressed air
to clean.
Clean strainer basket.
Check that mounting bolts of V-Green 165
and pump are tight.
Check that V-Green 165 is spinning by
looking at fan on back of V-Green165. If
so, check that pump impeller is correctly
installed.
Check plumbing connections and verify
they are tight.
Check for blockage in strainer or suction
side piping.
Checked for blockage in discharge piping
including partially closed valve or dirty
pool filter.
28