Motor Pause; Temporary Stop With Digital / Serial Input - Speck pumps EasyFit 1.65 THP Installation, Operation And Service Manual

6.8

Motor Pause

The V-Green 165 user interface has a "motor pause" feature that will
allow the user to temporarily stop the V-Green 165 for maintenance work
without disrupting the 24 hour schedule (i.e., for backwashing the filter).
If the V-Green 165 is currently running, the user can press and hold the
START button for more than three (3) seconds and the V-Green 165 will
stop and remain off until the user presses and holds the START button
again for more than three (3) seconds. The START and OVERRIDE
buttons will blink once every second indicating that the "motor pause"
feature is enabled. These LEDs will stop blinking once this feature is
canceled.
6.9

Temporary Stop with Digital / Serial Input

Temporary stop functionality only works while the V-Green 165 is being controlled by a
digital or serial input. If the motor is being controlled by the integrated key pad and STOP
is pressed, the motor will stop and remain stopped.
The V-Green 165 has a "temporary stop" feature that will immediately
stop the V-Green 165 when being controlled by a serial or digital input.
The user can press the STOP button while the V-Green 165 is running
and the V-Green 165 will stop and stay off for four (4) minutes. Once
this time has elapsed, the V-Green 165 will return to normal operation
and accept an input from digital or serial input source. Refer to section 9
for additional details on digital inputs.
NOTE: If the V-Green 165 is operating from serial or digital input, the
'0 RPM' LED of the bar graph will blink once every second indicating the
"temporary stop" feature has been activated. After the specified time
period, the V-Green 165 will return to normal operation and accept an
input from any digital or serial input source. Refer to section 9 for ad-
ditional details on digital inputs.
21
v