Dip Switches - Speck pumps EasyFit 1.65 THP Installation, Operation And Service Manual

v
NOTE: If no digital input is detected, the V-Green 165 will automatically
start the 24 hour schedule if the START key was pressed prior to the
application of a digital input.
Access to these terminals is in close proximity to the mains connectors which carry line
voltage capable of causing personal injury or damaging the equipment if contact is made.
Power should be turned off when accessing this area.
System Level Control
Figure 7: System Level Control Wiring Diagram
10

DIP Switches

Access to these terminals is in close proximity to the mains connectors which carry line
voltage capable of causing personal injury or damaging the equipment if contact is made.
Power should be turned off when accessing this area.
The DIP switches can be used to configure different settings for the V-
Green 165. Each DIP switch and their corresponding function is defined
in Table 5.
Switch # Function
1 Power output on/off
2 Not Used
3 Not Used
4 Not Used
5
Not Used
Table 5: DIP Switch Functions
Load Load
Relay 1 Relay 2 Relay 3
Line Line
Figure 8: DIP Switches
24
Load Load
Relay 4
Line Line