Schedule Advance - Speck pumps EasyFit 1.65 THP Installation, Operation And Service Manual

v
NOTE: Pressing/Holding OVERRIDE key for more than three (3)
seconds will cancel OVERRIDE mode.
NOTE: During the OVERRIDE mode, the V-Green 165 will not start with
the priming sequence.
NOTE: It is recommended that you do not set the OVERRIDE duration
to 0 HRS. Setting the OVERRIDE duration to 0 HRS will not allow you
to change the duration setting while the motor is running. The motor will
have to be stopped in order to change the OVERRIDE settings if the
duration is set to 0 HRS.
6.6

Schedule Advance

Do not perform any maintenance on the motor while the motor is in Schedule Advance
Mode. The motor may start without warning. This event could cause death or serious
The Schedule Advance mode allows the user to press the START button
at one time of the day, with the 24-hour schedule starting at a different
time of day. The V-Green 165 can run in the Schedule Advance mode
(by using the OVERRIDE button) and upon completion will begin the
programmed 24 hour schedule at STEP 1 DURATION and SPEED.
The following steps should be followed to set Schedule Advance mode:
1. With the V-Green 165 stopped,
press and hold the START key for
more than three (3) seconds. The
START LED will blink at a rate of one
second per pulse. The DURATION
setting LED and respective bar graph
LED will remain turned ON until the
Schedule Advance mode is complete.
DANGER
personal injury.
18