Speck pumps EasyFit 1.65 THP Installation, Operation And Service Manual page 7

SECTION 2 TROUBLESHOOTING GUIDE - continued
PROBLEM
7. Motor overload protection
"kicks out".
SECTION 3 SERVICING INFORMATION
When calling the manufacturer regarding a question or
problem with your pump, please have the serial number
available.
SECTION 4 LIMITED WARRANTY
Speck Pumps-Pool Products, Inc. grants solely to the original consumer purchaser ("Buyer") of the pump and motor the
following personal, non-transferable and limited warranty on the following terms and conditions (the "Limited Warranty"): the
pump and motor is warranted to be free of material defects in materials or workmanship under normal use for a period of two
(2) year beginning on the date of the Buyer's purchase of the pump and motor. Not withstanding any provisions herein to the
contrary, the warranties and obligations hereunder shall not in any event extend for more than three (3) years beyond the
date of shipment of the pump and motor from the factory (the "Limited Warranty Period"). The Limited Warranty is subject to
each of the following additional terms and conditions:
1. IN THE EVENT OF ANY BREACH OF THE LIMITED WARRANTY, SPECK PUMPS - POOL PRODUCTS, INC.'S
ENTIRE OBLIGATION AND LIABILITY TO BUYER, AND BUYER'S SOLE AND EXCLUSIVE REMEDY SHALL BE AS
FOLLOWS: Speck Pumps - Pool Products, Inc. will, at its option, either repair or replace the pump and motor or refund to
Buyer the purchase price actually paid by Buyer for the pump and motor subject to the Limited Warranty. Speck Pumps
- Pool Products, Inc. shall have no obligations under the Limited Warranty unless Buyer delivers timely written notice to
Speck Pumps - Pool Products, Inc. of the Limited Warranty claim within the Limited Warranty Period and returns the pump
and motor to Speck Pumps - Pool Products, Inc. if requested. To the fullest extent permitted by law, Speck Pumps - Pool
Products, Inc. expressly disclaims any liability for, and the Limited Warranty does not include or cover, any labor, costs or
other expenses in connection with the removal, transportation, shipment, insurance, replacement, repair, or installation of
repaired or replaced parts or for any other costs or expenses or damages to property or things including, but not limited to,
those arising in connection with the use of, or inability to use, the pump and motor.
2. To the fullest extent permitted by law, the Limited Warranty will be void and of no force or effect and Speck Pumps - Pool
Products, Inc. will have no liability, responsibilities or obligations to Buyer or with respect to the pump and motor in the event
of the occurrence of any one or more of the following:
(a) Any damage to the pump and motor caused by Buyer, any third party, ground movement, other natural forces, acts of
God or any other sources or causes not arising from a breach of the Limited Warranty, excluding ordinary wear and
tear;
(b) Any replacement, modification, alteration or repair of any parts or components of the pump and motor by anyone
other than Speck Pumps - Pool Products, Inc.;
(c) Any abuse, misuse, accident, tampering with, improper installation or modification of the pump and motor or any other
actions, inactions or failures to act that violate the terms and conditions of this Limited Warranty;
POSSIBLE CAUSES
a. Motor is not connected properly.
b. Low voltage due to under size
wire or low incoming voltage.
c. Wrong size heaters in protective
device.
d. Overload due to binding in pump
or wrong size impeller.
Check wiring diagram on motor.
Check with volt meter. Increase size of supply wire.
Reports low supply voltage to power company. Voltage
at motor must be within 10% of motor nameplate
voltage.
Heaters should be one size larger than full load amps
shown on motor nameplate.
Indicated by high amperage readings on motor,
binding shaft. Disassemble unit and correct.
The serial number is located on the pump either on the
casing and/or motor. Replacement parts may be available
from your installer.
SOLUTION
2999999319 - Rev. 0215 - EasyFit