Running V-Green 165 From Keypad - Speck pumps EasyFit 1.65 THP Installation, Operation And Service Manual

Duration
Speed
6.4

Running V-Green 165 from Keypad

If power is connected to the V-Green 165 motor, pressing any of the following buttons
referred to in this section 6.4 could result in the motor starting. Failure to recognize this
could result in personal injury or damage to equipment.
1. Press the START key and the V-Green 165 will run the programmed
24 hour duration schedule. The START event will be stored in the
controller. Should a power outage occur, the V-Green 165 will
automatically re-start at STEP 1 when power is restored.
2. The V-Green 165 will always run the PRIMING sequence when it
starts from the OFF state, including when it automatically restarts
following a power outage. The default Prime setting is defined in the
"Priming" section of this document.
3. The V-Green 165 then starts running in STEP 1 at the programmed
DURATION and SPEED. The "ACTIVE LED" for STEP 1 will turn
ON. The DURATION and SPEED setting LEDs along with the re-
spective bar graph LED will blink back and forth every three (3)
seconds.
Setup #2
Step 1 Step 2
Table 4: Custom Schedule
15
v
Step 3