Table of Contents
Advertisement
5. Slide the control button up again to the high (H) setting, you should feel a check to
the button movement at this position. The outer radiants should now be on their high
setting.
Settings.
The slider control settings are shown in the table below:
Control Positions
IGNITION / LOW (
MEDIUM (M)
HIGH (H)
OFF (O)
Note i) If the flames go out while setting the control, repeat the full lighting
procedure. If the flames repeatedly go out have the fire serviced.
ii) Please note. The radiants will take time to warm up. Although some glow
will be seen after approximately ten minutes, the full visual effect will only be
apparent after a somewhat longer time.
iii) The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to the high (H) setting.
To turn the fire off.
1. Slide the control button up again to the off (O) position. Both pilot and all radiants
should go out. While cooling the radiants may make some crackling noises. This is
quite normal. Wait at least three minutes before attempting to relight.
Lighting with a match or taper.
(See figure 3).
In the unlikely event of failure of the ignition spark, the pilot can be lit by a taper or
long spill. Slide the control knob to the ignition / low position (
the knob depressed, light the pilot by inserting a long match or taper into the opening
shown in figure 3 (Second opening on the right).
When the pilot is alight, keep the knob depressed for about ten seconds to allow the
flame sensing probe to warm up before setting to your preferred heat level.
For your own convenience, have the heater serviced as soon as possible.
©
GDC Group Ltd. 2011
OWNER GUIDE
Ignition / Centre radiants fully on. Outer radiants off.
L)
Centre radiants fully on. Outer radiants on low.
All radiants fully on.
Pilot and all radiants off.
Page 36
Radiants Condition
L). While keeping
Advertisement
Chapters
Table of Contents
