Table of Contents
Advertisement
INSTALLER GUIDE
7. APPLIANCE INSTALLATION
7.1 Installing to a hearth.
1. Place the fire centrally on the hearth making sure that the spigot lines up with the
spigot hole in the closure plate. Gently slide the appliance into place, being careful
not to scratch the hearth. The spigot must enter the closure plate to a depth of at
least 38mm.
2. Level the fire by loosening the lock nuts and turning the levelling screws in the feet
up or down as required while they bear on the hearth. When the fire is level and
square to the wall, tighten the lock nuts.
7.2 Wall mounting.
The fixing hole positions in relation to the
flue spigot opening are shown in figure 10.
Mark these positions on the wall. The
positions can alternatively be marked by
placing the fire in position and marking the
wall through the holes in the back panel.
Drill and plug the holes using no.10 wall
plugs. Place the fire in position and secure
with four no.10 x 2in. wood screws.
7.3 Gas supply connection.
8mm rigid tubing must be used to connect
the gas supply to the appliance. An olive
and nut are provided for connection to the
inlet "T" connector on the appliance. The
connector can be rotated to allow
Figure 10. Wall fixing holes
connection from either side or the rear. The
connector includes a valve for isolating the gas supply, ensure that the isolating valve
is open then replace the end cap.
Pressure check the installation pipework for gas soundness. In the United Kingdom
check in accordance with the current edition of BS6891. In the Republic of Ireland
refer to the current edition of IS 813 "Domestic gas installations".
7.4 Radiants installation.
Important: Fit the radiants ensuring that their rear face rests against the horizontal
ribs in the rear panel. There will be a small gap between their bottom front edges and
the retaining channel at the front of the radiant box.
Page 19
©
GDC Group Ltd. 2011
Advertisement
Chapters
Table of Contents
