D-Link DSL-302G User Manual page 85

Introduction
The Drivers are version 1.0.0000E
The Installer is version 1.0.2
MAC OSX Operating System Version Compatibility
This driver was developed for Operation under Mac OSX 10.1 and Mac OSX 10.2
This driver CANNOT be used with MacOS9 or earlier.
This driver CANNOT be used with Mac OSX version 10.0
Unless otherwise noted, these drivers were not developed for any particular version of Mac OSX 10.1 or OSX
10.2 and should work with all available versions. However, please note that the vast majority of the testing of
this package has been done with the latest versions available during the latest weeks of its development: Mac
OSX 10.1.5 & Mac OSX 10.2
Installation and Connection Establishment Instructions
Make sure you have Administrator rights for your account, as you will need to authenticate as such.
Unlike Mac OS9, Mac OSX allows several network adapters to be "bound" to TCP/IP at the same time. In order
to avoid routing problems, the following instructions assume your computer is stand alone and NOT connected
to any network (Ethernet, Airport, etc) at the time of the Installation of the D-Link DSL-302G. Make sure you
disconnect any existing network connection (i.e.: unplug the Ethernet cable) and restart the computer before
starting the installation
USB Installation (One time only)
1. Insert the Driver CD into your Mac CD-ROM, then you can find
the icon "DLINK_DSL302G_DRIVER" on your Mac Desktop.
2. Double click on the icon "DLINK_DSL302G_DRIVER", then on
the folder "Driver", there is the folder "Mac".
DSL-302G ADSL Modem User's Guide
2