D-Link DSL-302G User Manual page 44

DSL-302G ADSL Modem User's Guide
Next, you need to confirm that Network Address Translation (NAT) is enabled on the modem. Open the WAN
folder (if it is not already open) and click on the NAT link. This will open the Network Address Translation
(NAT) Configuration menu, as shown below.
Click the Enable click-box, and then click the Submit button to make the change current.
Finally, you will need to open the Admin folder and then click on the Save & Reboot link to open the Save &
Reboot menu, and finally click the Save button to enter the settings into the modem's permanent memory.
You will need to set your computer to Obtain IP address automatically to connect to your ADSL service
provider's network and the Internet. Instructions about how to do this are included earlier in this DSL-302G
User's Guide, if you do not know how.
26